Pacman Display
por rishuu en Printables
A pacman display that moves back and forth on the Y axis.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo sin pedir permiso ni dar crédito.
Al descargar aceptas respetar la licencia y dar crédito a rishuu.
Archivos (11)
- Pacman Holder.step STEP · 20 KB
- ConnectorStem.step STEP · 10 KB
- BackLid.step STEP · 60 KB
- Pacman.step STEP · 175 KB
- Assembly.3mf 3MF · 352 KB
- Healical Gear (10x30).step STEP · 585 KB
- FrontLid.step STEP · 50 KB
- AssemblyF3D.f3d F3D · 4,3 MB
- MainPlate.step STEP · 77 KB
- Assembly.stl STL · 1,1 MB
- Healical Gear (30x30).step STEP · 1,3 MB
- Categoría
- Figuras y arte
- Formatos
- STEP, 3MF, F3D, STL
- Descargas
- 0
- Publicado
Sobre este modelo
A Pacman Display that runs on a dc motor, it moves up and down when the helical gears move giving it a floating effect! Assembly:- - Take the main base and place the bigger gear in the pin and mount the other one to the motor.
- Place the pacman holder over the elevated portion of main base.
- Use heat inserts or glue the connector stem to the elevated cylinder on the bigger gear.
- slide the pacman's stem into the pacman holder and glue the elevated cylinder of it to the connector stem.
After the main assembly is done, glue some 5x1.5 neodymium magnets in the circular spots on the base plate , toplid and bottomlid.
After the Assembly is done your pacman display should look like this.
Descripción original del autor, publicada en Printables.
