Olfa L-1 (18mm - 3/4") wall holder
por GabC en Printables
A very simple utility knife holder fit for the Olfa L-1. It fastens with one #6 (or equivalent) countersunk screw.
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a GabC.
Archivos (1)
- Categoría
- Organización
- Formatos
- STL
- Descargas
- 1
- Publicado
Sobre este modelo
After searching for simple wall holders for an Olfa knife, I wasn't satisfied with anything. They all either held the knife from one end or were dependent on how far the fastening knob was on the knife. This hook cradles the knob with a brand new blade fully retracted and the knife can be taken out without having to slide it out of a full loop. Printing Print it as oriented in the file. You might need a brim but I didn't. It prints without supports.
Descripción original del autor, publicada en Printables.
