Nut cover 17 mm for Ford Focus
por Andriy en Thingiverse
I measured the width of the sides on the nut, and on this machine it’s 17.8 mm, so if you have the same nut, the cap will fit snugly, but you’ll still be able to remove it by hand or with special tweezers. I printed it with TPU, but PETG should work too.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Andriy.
Archivos (1)
- Categoría
- Repuestos
- Formatos
- STL
- Descargas
- 4
- Publicado
Sobre este modelo
I measured the width of the sides on the nut, and on this machine it’s 17.8 mm, so if you have the same nut, the cap will fit snugly, but you’ll still be able to remove it by hand or with special tweezers. I printed it with TPU, but PETG should work too.
Descripción original del autor, publicada en Thingiverse.
