Nuraphone USB conversion port

This is to accomodate a USB C port modification on a pair of Nuraphones. This should be snug fit for both the USB C port and the print itself within the nuraphones, I haven't needed to use any glue. The rest of the work required is soldering a couple of wires up to certain pads to bypass the original port. (quite awkward small soldering pads) Instructions for the rest of the wiring needed can be found on this reddit post: https://www.reddit.com/r/Nuraphone/comments/1rlmpys/completing_nuraphone_pinout_success/ Nuraphone _port _USB _C is the file that's ready to be used Nuraphone_port is if you'd like to develop your own for a different port or would like to fine trim the dimensions for the USB port. It's just the raw blank that slots into the Nuraphone. (make sure you've finalised your soldering before press fitting it all together, the USB C port is easier to remove but once you've pressed the print into the headphones it can be tricky to take out, your best bet is pushing it from the inside)