Nukatap Bottle Filler Station: fridge mount, bottle lift and adapter rack

Bottling from the keg without a third hand. This is a fully printed station for the KegLand Nukatap counterpressure bottle filler: - the filler head hangs on the side of your kegerator, - a lever lift presses the bottle up onto it, - a foam chute catches what the gas-out valve spits, - the adapters for five bottle types wait on a rack next to it.

Lift the head off by its handle and it's a one-hand filler. Want to see Version 4.7 in action? Join me on Instagram @TheTechBrewer https://www.instagram.com/thetechbrewer/ ▶ The video shows the whole build, part by part, and a bottle being filled. What you get: - Fridge mount: a taped backplate with dovetail rails. The head slides on and locks with one peg. The valve clamp holds the shut-off valve above the filler. No screws into your fridge. - Lever handle: stays on the head, docked or handheld. Slide the head on and off by it, and fill by hand with it. - Foam chute: slides in under the head and drains into a glass. - Bottle lift: swing it out, put the bottle on, swing it in and pull the lever. About 90 N presses the bottle onto the seal. Cams with hard stops, an interlock so it can't swing while lifted, and spring-loaded adapters. - 5 screw-on adapters: BNR / 25 cl, longneck, 50 cl, 75 cl Belgian and 75 cl champagne, with TPU pads. - Adapter rack: three prints that click together. Tape it on, or screw it to a wall.

Profiles for every Bambu Lab printer Ready-sliced multi-plate projects for the A1 mini, A1, A2L, P1P, P1S, P2S, X1, X1 Carbon, X1E, X2D, H2C, H2D, H2D Pro and H2S. Every part fits the A1 mini. Plates are sorted by section and colour, about 9 h max each. Every part has its own tuned walls, infill and brims. Supports only where needed, and normal supports that peel off in one piece; they never touch a dovetail. Start with the fit-test plate: one copy of every fit in the build. Two kinds of profile - Full station: fridge mount, handle, lift, rack and all adapters (17–23 plates). - Handheld only: just the filler head with the lever handle (and the knob as an alternative), foam chute, about 5 plates. The same head docks onto the fridge mount later.

What you need - KegLand Nukatap counterpressure bottle filler, Duotight 8 mm ball valve, 8 mm EVABarrier tube - one compression spring stainless 302, 2 × 27 × 195 mm, 0.69 N/mm (Amatec D22830, stainless) - 3M VHB tape - about 1.7 kg PETG (1 kg black, 0.7 kg orange) and 45 g TPU (or a silicone sheet)

Every screw is printed. Want steel? Each printed screw has a stock stainless replacement (DIN 912 / 985 / 1587, ISO 7379), and the README lists which one fits where.