Nikon HB-69 18-55mm VRII New lens hood

This hood is for new Nikon 18-55mm VRII lens with 2 prongs, other designs on internet with same profile have 3 prongs and does not fit on new lenses, it is also reversible for storage like originally designed to be.

Camera in the picture is Nikon D5500 Lens - 18-55mm VRII

Print Settings Printer: TEVO Tarantula

Rafts: No

Supports: No

Resolution: 0.15

Infill: 20%

Notes: Material - PLA Print Speed - 60 Nozzle - 210 Heat bed - 60

Pre-Printing - Filament and time saving tip Start a print let it print a couple of layers and then stop and cancel the print and check the printed ring size with your camera lens, if it is correct re-print a new one, if not then resize it to make it correct, I got it right on first test. Post-Printing

May have to sand a bit depending upon the accuracy and calibration of printer, I had to sand prongs a bit to thin them on edges. If it is tight fit you can use hair dryer or heat gun to heat it up and then fit it on lens and let it cool to take a required shape. How I Designed This

Remixed in - Windows 3d Builder

Remixed from design by

Perry Roth-Johnson