NIH Surgical Mask Tension Release Band - Ear Savers

This is the NIH approved Surgical Mask Tension Release Band. I am only posting this here to provide an easy reference to print files and gcodes for printers to be used by Prusa Groups. It was invented by someone else, and is listed on various websites.

https://3dprint.nih.gov/discover/3dpx-013410

So far we have been able to print and distribute over 1900 in the Omaha, NE metro area. I have found that a mix of small and large are needed, and I have included gcode to print in sets of 9 and 11.

Group: https://www.prusaprinters.org/group/midwest-printers-omaha-KRnPPQE

EDIT: Sorry I neglected this, I had no idea so many were downloading from here. I am in the process of adding various layouts and versions. The layouts help prevent sheet damage by allowing the printer to cycle thru various layouts instead of using the exact same spot and wearing out the PEI; especially on the smooth sheets in PLA. I also have found that most facilities prefer the 100% sized band now (for adults), and local hospitals have started to allow custom versions that save materials. I know there are a ton of variations now, but these are the models we have been distributing in the Omaha area.

UPDATE COMPLETE: Full Sheet files and gcodes have been uploaded. NIH versions scaled at 100% and 85%, as well as minimal version that is pending NIH review. It uses about 30% less filament.

Print instructions PETG or PLA

.4mm Nozzle

.3mm Layer Height

I found that using a .6mm nozzle did not justify the loss in quality for the savings in time. Maybe a certain forum poster will stop by and provide tips on increasing speed and size without losing quality.

GCodes sliced for Prusament PLA & PETG