Neodymium magnet holder for cabinet door.
por Rahman Sattaur en Thingiverse
Holds a couple of 5 mm X 2 mm Neodymium magnets for attaching to the inside edge of a cabinet. Countersink screw holes are 3 mm in diameter. I super glued the magnets in place. The size is 22 mm long with 12 mm wings. Printed without supports at 237 degrees and a bed temperature of 80 degrees using.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Rahman Sattaur.
Archivos (1)
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
Holds a couple of 5 mm X 2 mm Neodymium magnets for attaching to the inside edge of a cabinet. Countersink screw holes are 3 mm in diameter. I super glued the magnets in place. The size is 22 mm long with 12 mm wings. Printed without supports at 237 degrees and a bed temperature of 80 degrees using a Snapmake 2 A350. and white PETG filament.
Descripción original del autor, publicada en Thingiverse.
