Mushroom Caps for Glowing Mushroom Light
These are the mushroom caps I printed for my DIY glowing mushroom lamp (https://youtu.be/XHvqdc5Nbr0). The stems were made with a 3D pen (https://makeanything.design/favorites/#3Dpens).
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Devin B.
Archivos (23)
- cap1.stl STL · 3,1 MB
- cap2.stl STL · 1,2 MB
- cap3.stl STL · 1,1 MB
- cap4.stl STL · 1,1 MB
- cap5.stl STL · 1,2 MB
- cap6.stl STL · 1,2 MB
- cap7.stl STL · 1,1 MB
- cap8.stl STL · 1,2 MB
- cap9.stl STL · 972 KB
- cap10.stl STL · 972 KB
- cap11.stl STL · 1,5 MB
- cap12.stl STL · 980 KB
- cap13.stl STL · 981 KB
- cap14.stl STL · 1,0 MB
- cap15.stl STL · 1,0 MB
- cap16.stl STL · 1,1 MB
- cap17.stl STL · 986 KB
- cap18.stl STL · 977 KB
- cap19.stl STL · 979 KB
- case-bottom.stl STL · 70 KB
- case.stl STL · 5 KB
- panel-1.stl STL · 5 KB
- panel-2.stl STL · 5 KB
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 332
- Publicado
Sobre este modelo
These are the mushroom caps I printed for my DIY glowing mushroom lamp (https://youtu.be/XHvqdc5Nbr0). The stems were made with a 3D pen (https://makeanything.design/favorites/#3Dpens).
I also included the files for the base of my light, although it was made especially for my piece of wood... it might be useful just to take a look at though!
For best results print with a glow-in-the-dark PLA filament (https://amzn.to/43QDYDN).
Descripción original del autor, publicada en Thangs.
