Monitor stand Legs
por David Miao en Thingiverse
These are legs I created to use with a piece of wood to create a stand for your monitor. You will need 3/4 wood at 8 inches deep to friction fit into the slot. The length is up to you I suggest if you use it longer use more legs to counter any bowing. You just need to slide the piece further into...
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a David Miao.
Archivos (1)
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 19,688
- Publicado
Sobre este modelo
These are legs I created to use with a piece of wood to create a stand for your monitor. You will need 3/4 wood at 8 inches deep to friction fit into the slot. The length is up to you I suggest if you use it longer use more legs to counter any bowing. You just need to slide the piece further into the middle where you need support. The design inside is based on your infill pattern. I used a honeycomb with no top and bottom layers. You want your thickness of walls set to 9. Pictured is honeycomb at 6% infill and no rotation on the pattern. You can have fun with trying gyroid triangles etc.
Descripción original del autor, publicada en Thingiverse.
