Monitor Stand for SL88 MK2 Keyboard
por Maximilian en Printables
A modular monitor stand for the Studiologic SL88 MK2 keyboard that can be attached with the existing screws on the back.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Maximilian.
Archivos (4)
- Categoría
- Tecnología
- Formatos
- 3MF, STL, BLEND
- Descargas
- 0
- Publicado
Sobre este modelo
This design is modular and consists of two pieces - the lower piece that needs to be screwed into the back of the keyboard (with the screws that are already there), and the upper piece that gets plugged into the lower piece and acts as the actual monitor stand. So you can quickly remove the upper piece and replace them with other fitting modules (like a laptop stand or a music note stand) without having to remove the whole thing. While I have not tested it (as I only have the SL88 MK2), I believe this stand should also work for the SL73 MK2 and the SL88 GT MK2 - as long as it's the MK2 variant. Print instructions - Printer: Bambu P1S
- Filament: PLA Matte
- Print profile: 0.16mm Optimal
- Support: Yes (On Build Plate Only, Treshold Angle 25°)
- Sparse Infill Density: 30%
Additional notes I have three of those holders screwed into the back of my keyboard for half a year and it seems solid enough, but if you were to use a touchscreen or heavier monitors, I'd definitely recommend more sparse infill density or a more solid filament.
Descripción original del autor, publicada en Printables.
