Modular Reversable Clamp V2

Based on commonly found bar and pipe clamps adjusted for 3d printing. Each of the clamp tubes adds 15cm of length to the clamp. Can be used as a clamp or reversed as an anti-clamp. Meant for light to medium clamping jobs. Working on a version that uses extruded aluminum as a tube for added rigidity. Printing: - Note: not all parts are oriented correctly; adjust in the slicer for best printability/strength

- Support: Most parts will need support, especially the clamp jaw and vise housing

- Strength: Use as many walls as you think necessary; I used around 5 walls @.4mm.

Parts: - 4x Clamp stop

- 1x Clamp vise housing

- 1x Vise foot

- 2x Clamp stop screw

- 1x Clamp vise screw

- Clamp tube(print as many as you want)

- 1x Clamp Jaw

Assembly: - Clamp Jaw: - Thread vise screw through back hole all the way.

- Position one clamp stop on each side of the screw, aligning the groove on the screw with the one on the stop

- Unscrew the stop until it fully seats and both stops remain in contact with each other.

- Clamp vise: - Repeat steps for Clamp Jaw

- Screw vise screw through top of front hole.

- Press fit foot onto screw

- Clamp tube: - Screw 2 tubes together until seams align(may require wrenches if fit is poor)