Modular Organizer

Tired of messy drawers and tangled cables? This modular grid organizer system is designed to turn drawer chaos into perfect order. Heavily inspired by the Gridfinity ecosystem, this setup features custom-sized bins tailored for desk supplies, electronic components, and small parts.

This specific version features built-in magnet holes at the base, allowing you to snap the bins securely into any standard Gridfinity baseplate, preventing them from sliding around when you open and close your drawer.

NOTE : The custom sizes bin are not included here, since they are item specific, i only uploaded the generic one 📦 Included Bins & Features

Magnet Ready: Features 4x1mm magnet holes on the bottom of each bin. Cable & Wire Storage: Deep compartments perfect for managing USB cables, chargers, and headphone wires. Small Parts Trays: Shallow, scoop-bottom sections ideal for paperclips, screws, SD cards, or stationery. Modular Flexibility: Mix, match, and rearrange the layout to perfectly fit your workspace.

🖨️ Recommended Print Settings

Material: PLA or PETG (PLA works great for desk organization) Layer Height: 0.2mm for a good balance of speed and clean walls Infill: 10% to 15% (Gridfinity bins don't need heavy infill) Supports: No supports needed! The magnet holes and slopes are designed to print cleanly on any well-tuned printer. Bottom Layers: 3–4 layers to ensure a solid base for the magnets.

🧲 Assembly Notes

The magnet pockets are designed for standard 4mm x 1mm neodymium magnets. A tiny drop of superglue (CA glue) in each hole ensures the magnets stay locked in place permanently. Make sure to check your magnet polarities before gluing so your bins match your baseplates!