Modular Desk Organizer
por Isadora Marta en Printables
A desk organizer with modular stacking!
Licencia
Revisa las condicionesEl autor usa su propia licencia. Revisa sus condiciones en la página original antes de compartir, modificar o vender.
Al descargar aceptas respetar la licencia y dar crédito a Isadora Marta.
Archivos (8)
- Categoría
- Hogar
- Formatos
- STEP, GCODE
- Descargas
- 1
- Publicado
Sobre este modelo
This is a fun modular desk organizer! It features a variety of components, and you can print as many or as few as you want. I made this model so I can be more organized. See below for individual print instructions for each component. Each component is 3" x 3" x 4" Minimum space required to print all components at once is 9" x 6" x 4" Each component takes ~5.5 hours to print (give or take an hour). If printing all components at once, it will take about 40 hours. Z-SHAPED PENCIL HOLDER - Print on side for minimal support usage
- Connectors on bottom only
SQUARE TRAY - Print on side for minimal support usage
- Connectors on bottom and top
EARRING STAND - Print on side for minimal support usage
- Connectors on bottom and top
HOOKS - Can be printed on back or upright.
- If printed on back, you probably don't need supports, but it might be best to use them just in case
- Connectors on bottom only
A-FRAME TOOL HOLDER - Print on side for minimal support usage
- Connectors on bottom only
DRAWERS - Print frame on back for minimal support usage
- Print the drawer upright
- Not print-in-place; print the frame and both drawers separately
- Connectors on bottom and top
Descripción original del autor, publicada en Printables.
