Modern Corner Shower Shelf

I designed this corner shelf to keep bottles, a soap bar and a toothbrush together in a simple, tidy layout. It has rounded sides, a separate soap tray and a built-in toothbrush pocket, and prints as one piece. The shelf has been printed in dark-grey PETG-CF on my Bambu Lab P1S and installed in my shower. The supplied print project is the version I used. Features

- L-shaped layout for a 90° shower corner.

- Bottle storage along the longer arm.

- Separate soap section with drainage slots.

- Integrated toothbrush pocket at the outer end.

- Rounded edges and a raised front lip.

- Tall, flat rear panels for double-sided mounting tape.

- One-piece print with no supports or assembly required using the supplied profile.

Size Approximately 223 × 244 × 74 mm overall, as supplied in the print project. Check the available space in your shower before printing. Printing The supplied profile uses a Bambu Lab P1S with a 0.4 mm nozzle, PETG-CF, 0.16 mm layers, 2 walls and 15% gyroid infill. Supports are disabled. Print with the flat underside on the build plate, in the orientation saved in the project. Mounting Use double-sided mounting tape suitable for wet areas and compatible with both the tile surface and the printed material. Apply it to the flat rear panels. Prepare and dry the surfaces, then follow the tape manufacturer's application and bonding-time instructions before loading the shelf. Holding strength depends on the tape, surface and installation. Use and remixes Personal printing and non-commercial sharing and remixes are welcome under CC BY-NC-SA 4.0. Credit the original design, link the licence, identify any changes, and share remixes under the same licence. Commercial use is not included.