Mobile Phone Tripod
por Nat Gazer en Thingiverse
If you're having trouble downloading through thingiverse, you can use this link (no ads): shorturl.at/pvwNU This thing is 100% 3D printable, but you might use pen springs as shown in the image If you want to support my work, you can get a custom tripod by sending me an e-mail with a word or a...
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo dando crédito al autor.
Al descargar aceptas respetar la licencia y dar crédito a Nat Gazer.
Archivos (11)
- Mobile_phone_width_other_than_7.73_cm.zip ZIP · 7,5 MB
- 1_head_screw_7.73cm.stl STL · 439 KB
- 2_head_support_7.73cm.stl STL · 1,6 MB
- 3_middle_support_7.73cm.stl STL · 1,2 MB
- 4_joint_support.stl STL · 2,3 MB
- 5_angle_screw.stl STL · 165 KB
- 6_supreme_joint.stl STL · 6,1 MB
- 7_angle_leg_screws.stl STL · 371 KB
- 8_outer_leg_x3.stl STL · 1,1 MB
- 9_length_leg_screws.stl STL · 338 KB
- 10_inner_leg_x3.stl STL · 642 KB
- Categoría
- Tecnología
- Formatos
- ZIP, STL
- Descargas
- 37,540
- Publicado
Sobre este modelo
If you're having trouble downloading through thingiverse, you can use this link (no ads): shorturl.at/pvwNU This thing is 100% 3D printable, but you might use pen springs as shown in the image If you want to support my work, you can get a custom tripod by sending me an e-mail with a word or a simple black and white image. For example the pictures I took have a "RF" engraved I strongly recommend to increse the infill the the screws and the outer leg models to at least 60% to ensure a resistant tripod. [email protected] Minimum height (legs horizontally): 16 cm Normal height : 29 cm Maximum height : 35 cm Give me feedback in the comments!
Descripción original del autor, publicada en Thingiverse.
