Minimalistic Phone Stand - only 3g!
por N1ckTr1ck en Printables
A phone stand that fits in every pocket and is printed in under 10mins for just 1c!
Licencia
Solo uso personalCC BY-NC-ND 4.0 — Atribución, no comercial, sin derivadas
Solo para uso personal, sin modificarlo y dando crédito. No se permite vender ni redistribuir cambios.
Al descargar aceptas respetar la licencia y dar crédito a N1ckTr1ck.
- Categoría
- Tecnología
- Formatos
- 3MF
- Descargas
- 0
- Publicado
Sobre este modelo
## Print it in under 10 minutes. Lose it. Print another one. That's the whole point. Two versions included: SLIM (8.5mm) – for naked phones WIDE (10.5mm) – for phones with a case  
Features: - PRINTS IN UNDER 10 MINUTES (Sport Mode) - ONLY 3 GRAMS OF PLA - FITS MOST PHONES (with or without case) - VERY EASY PRINT - POCKET-SIZED - SURPRISINGLY STRONG & STABLE
Most phone stands here on MakerWorld are great – but they're quite large, some take hours to print, and they sit permanently on your desk. This one fits in your pocket after you are done with meal-time-watching. In the last revision I added a small hole to attach it to my keys or something.
Print Instructions: Prints fine in Sport Mode or even Ludicrous Mode. No supports. No brim needed. Just hit print. PLA is recommended. Pick the colour and brand you like! :)
Descripción original del autor, publicada en Printables.
