Micro VTail Quadcopter
por Ulf Lindeström en Thingiverse
I've always been a sucker for different looking multirotors. After designing bigger frames I decided it was time for something smaller so I came up with this small (120mm MTM) brushed vtail quadcopter. It's designed to use Beef's Brushed Board but will fit any FC with the dimensions 32x32mm or...
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Ulf Lindeström.
Archivos (11)
- MicroVTail_Canopy.stl STL · 826 KB
- MicroVTail_Canopy_with_lens.stl STL · 859 KB
- MicroVTail_Skirt.stl STL · 174 KB
- MicroVTail_Canopy_with_antenna_and_lens.stl STL · 878 KB
- MicroVTail_Skirt_with_lens.stl STL · 183 KB
- MicroVTail_Frame.stl STL · 6,5 MB
- MicroVTail_Skirt_with_vents_and_lens.stl STL · 1,3 MB
- MicroVTail_Skirt_with_vents.stl STL · 1,3 MB
- MicroVTail_Rear_foot.stl STL · 58 KB
- MicroVTail_Front_foot.stl STL · 470 KB
- MicroVTail_Frame_v2.stl STL · 6,5 MB
- Categoría
- Repuestos
- Formatos
- STL
- Descargas
- 10,592
- Publicado
Sobre este modelo
I've always been a sucker for different looking multirotors. After designing bigger frames I decided it was time for something smaller so I came up with this small (120mm MTM) brushed vtail quadcopter. It's designed to use Beef's Brushed Board but will fit any FC with the dimensions 32x32mm or smaller. The frame only fits brushed 8.5mm motors. My setup is a bit on the heavy side. 75gr AUW with a 500mah 1S battery. It's not an acro frame... Let me know I you have any questions and I'll try to answer them. And please respect the licence...
Descripción original del autor, publicada en Thingiverse.
