Marking Gauge with (Folding) Ruler - Customizable
por MrFuzzy F en Thingiverse
Turn a carpenters folding rule or metal rulers into a marking gauge / depth stop. By tightening the lever the position of the ruler can be fixed. Printed in place. Best printed flat - as designed. Supports are required only towards printing bed, but no inner support. After printing the lever might..
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a MrFuzzy F.
Archivos (10)
- RulerMarkingGauge.stl STL · 488 KB
- RulerMarkingGauge_fence20x20.stl STL · 490 KB
- RulerMarkingGauge_FullFoldingRuler.stl STL · 490 KB
- RulerMarkingGauge_MetalRuler_32.6x1.2mm.stl STL · 496 KB
- RulerMarkingGauge_MetalRuler_13x0.5mm.stl STL · 494 KB
- RulerMarkingGauge_MetalRuler_30.6x1.7mm.stl STL · 496 KB
- RulerMarkingGauge_FoldingRulder_45deg.stl STL · 585 KB
- RulerMarkingGauge_MetalRuler_13x0.5mm_45deg.stl STL · 589 KB
- RulerMarkingGauge_FoldingRuler_45deg.stl STL · 584 KB
- RulerMarkingGauge.scad SCAD · 9 KB
- Categoría
- Herramientas
- Formatos
- STL, SCAD
- Descargas
- 18,816
- Publicado
Sobre este modelo
Turn a carpenters folding rule or metal rulers into a marking gauge / depth stop. By tightening the lever the position of the ruler can be fixed. Printed in place. Best printed flat - as designed. Supports are required only towards printing bed, but no inner support. After printing the lever might be sticky. To loosen it gently slide e.g. a flat knife between lever and housing. Design updated to support thin metal rulers. Don't tighten lever too much, otherwise ruler might cut into clamp. Updates: - [2019-05-12] Support for thin metal rulers (ruler bed raised if ruler thickness < 2mm) - [2020-12-27] Allow angled fence
Have fun!
Descripción original del autor, publicada en Thingiverse.
