Magneto Helmet: X-men First Class
por Andrew Diehl en Thingiverse
This is an adequately close model of Magneto/Shaw's helmet from x-men first class. Total print time is about 25hrs. Designed for a 7.5" head width. In hindsight it is a bit too big, and I would scale it by 7/7.5 if I were doing it again. The first one was printed on a Fablicator. www.fablicator.com
Licencia
Uso comercial permitidoPuedes usarlo, modificarlo y venderlo; si distribuyes versiones modificadas deben ir con la misma licencia y sus fuentes.
Al descargar aceptas respetar la licencia y dar crédito a Andrew Diehl.
Archivos (4)
- Categoría
- Cosplay y props
- Formatos
- STL, SLDPRT
- Descargas
- 22,036
- Publicado
Sobre este modelo
This is an adequately close model of Magneto/Shaw's helmet from x-men first class. Total print time is about 25hrs. Designed for a 7.5" head width. In hindsight it is a bit too big, and I would scale it by 7/7.5 if I were doing it again. The first one was printed on a Fablicator. www.fablicator.com
Descripción original del autor, publicada en Thingiverse.
