M203 Airsoft 40mm gas grenade launcher RC

My goal was once again to make this replica realistic as pissible so it could be used as prop for Vietnam war reenactment and also as a Airsoft gun and I think I came up with the best possible solution for both of the roles. Launcher is externally based on the G&P Airsoft replica but all of the parts were simplified for better printing and to make them more durable for Airsoft use. Model comes as a precut for smaller printers and also as a full no cut model. Handguard is only compatible with the realspec hanguard nut so it wont fit on cheap CYMA or JG Works guns but it does fit fine on GBBR and E&C replicas. Launcher it self should fit on any replica just fine. Assembly: All screws goes directly in to the plastick and glue is just for the precut two pieces barrel. For assembly you are gonna need: - 1x M3x29mm screw

- 4x M3x5mm screw - cut to 3mm

- 5x M3x10mm screw

- 2x 3x28 pin

- 2x 3x16mm pin

- 5x M4x12mm screw

- 2x M4x5mm scre

- 1x 13x18mm spring - is the same one as the AEG motor spring

- 2x pen spring

For the sight base and launcher mount piece you should use a small head screws. Let me please know on any problems you are gonna have with my launcher so I can fix them thanks :) Dont forget to share your prints with me :)