Low Poly Succulent Planter with Drainage & Saucer

A crisp, faceted low-poly planter for succulents, cacti and air plants, with a matching octagonal drip saucer. The pot's surface is made of large triangular facets, and a ring of eight navy triangles is inlaid flush into the white pot just below the rim, so the colour is part of the print, not paint or a sticker. No text and no logos. Healthy roots: an 8 mm drainage hole in the centre, plus a cross of 8 mm drain channels under the pot (four low feet), so water can drain into the saucer instead of pooling under the pot. The pot nests into the saucer with about 3 mm of side clearance all around. Dimensions (measured from the model): Pot: 90 x 90 x 80 mm (corner to corner), 83 mm across the flats at the widest point Opening: 68 mm across flats / 74 mm corner to corner Soil capacity: approx. 325 ml Wall: 2.4 mm. Inner floor 5 mm above the table (3 mm floor over the channels) Saucer: 89.5 x 89.5 x 16 mm, inner depth 13.6 mm, holds approx. 54 ml Height with the pot in the saucer: 82.4 mm Material: PLA (white body, navy inlay and saucer). For indoor use only; keep out of hot cars and direct sun behind glass. Plant not included. Print notes (for the STL/3MF files): Bambu Lab H2D, 0.4 mm nozzle, 0.20 mm layers, Bambu PLA Basic, default 2 walls / 15% infill No supports needed. All slopes are under 45 degrees, and the only overhangs are short 8 mm bridges over the drain channels Pot: load pot_body.stl (filament 1, white) and pot_accent.stl (filament 2, navy) as ONE multi-part object. The inlay is flush and 1 mm deep Saucer: single colour, prints flat in about 30 min. For a more water-tight saucer, use 3+ walls / 100% bottom layers, or seal it Sliced estimates (Bambu Studio, H2D): pot 2 h 36 min, 69.9 g. Saucer 30 min, 18.0 g. Both on one plate: 3 h 23 min, 90.9 g