Lenovo M4 Tab Tablet Wall Mount For Home Assistant

This is a 3 piece wall mount made to fit a Lenovo M4 Tab the 2 halves go together, The tablet slides in from the left side and then the end cap is put on. It is made to fit either over a single gang box or mounted directly to the wall. Wiring can come through the bottom or pass into the single gang box. I printed it with PETG-CF at .16 on my K1 Max You will need: • Right Angle slim USB C Cable • 7 x 3mm Heat press inserts • 5 x M3 x 8mm • 2 x M3 x 10mm • Wall anchors or screws to mount the base plate to the wall or box. There are previsions for the camera, speakers, mic, proximity sensor so all functions still work and can be used to set up as a motion / proximity sensor for home assistant so the tablet doesnt stay full brightness 24/7. The buttons on the top are power, volume up and down. The tablet does fit tight inside the mount which makes removal somewhat difficult. I found the best way is to remove the side cover, and push a ~4mm diameter rod into the mic provision on the right side to slide it out to a point where you can use your fingers to slide it the rest of the way. Ill upload photos later of the finished product.