Lego Flower with Pot
por Blake Smith en Thingiverse
Here's the Lego flower model that you all are looking for! Everything can be printed without support. The studs on the pot is 30mm and the stem is 30.4mm. The section on the stem where the flower goes is 7.5mm for a length of 20mm. The hole in the flower is 7.9mm so it can slip on easily. Also...
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Blake Smith.
Archivos (5)
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 15,531
- Publicado
Sobre este modelo
Here's the Lego flower model that you all are looking for! Everything can be printed without support. The studs on the pot is 30mm and the stem is 30.4mm. The section on the stem where the flower goes is 7.5mm for a length of 20mm. The hole in the flower is 7.9mm so it can slip on easily. Also, these models are not to scale. A big thanks to MagnumDanger for his Lego Wreath design https://www.thingiverse.com/thing:4676031, as this is what inspired me to design these models. I hope you all enjoy it as much as I do. Updated 2/17/2026 Added Lego Flower Pot with Open Bottom Changed Mounting Hole Sizes on Stems and Flower Hole in bottom of stem was 30mm now 30.4mm Hole in flower was 7.6mm now 7.9mm
Descripción original del autor, publicada en Thingiverse.
