LED Noodle Earrings - cr1025 battery holder
por BethFromAbove en Printables
A holder for a tiny cr1025 battery with holes for LEDs. Can be used to make glowing LED noodle earrings.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a BethFromAbove.
Archivos (1)
- Categoría
- Tecnología
- Formatos
- STL
- Descargas
- 14
- Publicado
Sobre este modelo
These LED earrings are super simple to make and very eye-catching in low light. Perfect for parties, raves, festivals or just being fabulous at home :) No soldering required! You will need: - Noodle LEDs (like these ones)
- CR1025 coin cell batteries
- Earring studs with flat fronts
- 3D printed holder
- Super glue
Simply insert the ends of the noodle LED so that the positive leg is wedged against the positive side of the battery and the negative leg is against the negative side. Use super glue to fix them in place if not wedged tight enough. Insert a thin piece of plastic between a leg and the battery to act as a switch if required. Print Settings: 20% infill, support required (print upright)
Descripción original del autor, publicada en Printables.
