Knot a Vase
por DaveMakesStuff en Thangs
Despite what you might think, this is “Knot a Vase.”
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a DaveMakesStuff.
Archivos (2)
- Knot a Vase (supports).stl STL · 60,0 MB
- Knot a Vase.stl STL · 57,7 MB
- Categoría
- Figuras y arte
- Formatos
- STL
- Descargas
- 213
- Publicado
Sobre este modelo
Despite what you might think, this is “Knot a Vase.”
The lattice structures are between 1.8mm – 2.0mm, so stick with a small nozzle. The model above was printed using a 0.4mm nozzle.
The pre-supported file has custom supports for the steepest sections, but with a structure like this it is inevitable that you will get small areas of print fail within the lattice. Best to clean this up with a small file afterwards than try to support every overhang.
Descripción original del autor, publicada en Thangs.
