Kitchen Sink Organizer with Magnetic Drain Tray

Update: Small design refinement ✨ I’ve added a V2 print profile with matching side textures on the basket and drainage tray for an even more cohesive look. The front and back already matched in the original version. For new prints, I recommend V2. If you’ve already started printing, V1 remains available so you can finish your set. ___________________________________________________________________________________

Keep your sink essentials together—and let excess water drain straight into the sink.

This kitchen sink organizer combines two spacious compartments with a removable magnetic drain tray. Rounded corners and a fine grid texture give it a distinctive look, while the separate basket and tray make cleaning easy.

Organized storage, direct drainage

The two compartments provide space for dish soap, sponges, brushes and other washing-up essentials. Open slots in the basket floor let water drain into the tray below. Its pronounced slope guides the water towards the outlet and into your sink.

Magnetic connection for easy cleaning

The basket and drain tray connect using 10 magnets in total, each Ø4 × 2 mm. Glue the magnets into the designated recesses with a small amount of superglue. Check the polarity before gluing so that each opposing pair attracts.

Once the glue has fully cured, simply lift off the basket to clean both parts, then place it back onto the tray.

Optional feet for slightly raised sink rims

The print profile includes two pairs of rear feet: • 3 mm height • 5 mm height

If your sink rim sits slightly above the countertop, these feet allow you to raise the rear of the organizer and increase its tilt towards the sink. Choose the appropriate pair and attach it to the designated positions with a little superglue.

Position the organizer so the outlet extends over the inside edge of your sink.

Dimensions

Overall: 200 × 213 × 137 mm (width × depth × height)

Internal compartment dimensions: • Left compartment: 70 × 110 × 94 mm • Right compartment: 115 × 110 × 94 mm

Printing

A print profile is included: • 2 walls • 5% Gyroid infill • No supports

Additional hardware

• 10 round magnets, Ø4 × 2 mm • Superglue for securing the magnets and attaching the optional rear feet

Boost MeThank you for your support! :)