Just in Case - PRINT IN PLACE - filament hinge
por Luke en Thingiverse
UPDATE 1: If you would like this to use as a key ring please check remixes. Little pun related print for Halloween. When people choose trick instead of treat give them this. ONLY 7 grams of filament. Under 2hr print time (I printed at 0.12 layer height) but even faster at 0.2mm layer height. 21...
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Luke.
Archivos (1)
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 8,458
- Publicado
Sobre este modelo
UPDATE 1: If you would like this to use as a key ring please check remixes.
Little pun related print for Halloween. When people choose trick instead of treat give them this.
ONLY 7 grams of filament.
Under 2hr print time (I printed at 0.12 layer height) but even faster at 0.2mm layer height. 21 minute print time amazing work! Click here for 38 minute print time - Print-In-Place - Handle moves! - Snap shut lock! - Stable when upright! - NOT ai
Hole for filament is 2.0mm. Before removing from build plate slide in filament (super easy fit) then take it off and snip both ends. All done.
Check out my other designs
Elegant Pen Cup Patreon
I have just started my Patreon take a look :) patreon.com/LGMdesign
Descripción original del autor, publicada en Thingiverse.
