JoJo Reef 04 - Reef Accent (2-part PETG)

Reef Accent — model 04 I made this little rock shape for my lagoon tank. It has a few flat shelves and an opening underneath. Print the two pieces on their cut faces, remove the supports, then dry-fit and glue them together. No connectors to line up. Assembled size: 110 x 70 x 68 mm. The taller shape on the left in the shared photos is this model; the shorter arch beside it is model 05. These are my real prints, shown from above and from two sides. Photos show earlier prints, not proof that every setting in the new file has been physically tested. The 3MF is for Bambu H2C, RIGHT 0.4 mm nozzle and AMS only. PETG Basic for the model and support trunks; Bambu Support for PLA/PETG for interfaces. 0.20 mm layers, 5 walls, 100% infill. Open as a complete project, check the actual AMS slots and start with a watched test print. The right-nozzle revision is checked in the slicer; clean any nozzle buildup and stop if paths start dragging or curling. The shape started with AI-generated geometry, then I edited it and prepared it for printing. Aquarium chemistry and long-term livestock safety have not been tested. Digital files for personal printing. The full five-model collection, or a way to support my work: https://www.patreon.com/JoJoReef3D/posts/five-reef-rocks-173160785