Jointed Ankylosaurus
por Patrick en Thingiverse
This is a Ankylosaurus model consisting of 18 parts, capable of limited articulation after assembly. Before you begin printing, please note the following: - Model Scaling: Scaling down the model is not recommended. However, depending on your filament quality, you may slightly upscale it. I...
Licencia
Solo uso personalCC BY-NC-ND 4.0 — Atribución, no comercial, sin derivadas
Solo para uso personal, sin modificarlo y dando crédito. No se permite vender ni redistribuir cambios.
Al descargar aceptas respetar la licencia y dar crédito a Patrick.
Archivos (24)
- Jointed_Ankylosaurus_PrusaSlicer.3mf 3MF · 57,4 MB
- Jointed_Ankylosaurus_PrusaSlicer_Bambu_Studio.3mf 3MF · 57,4 MB
- Body.stl STL · 67,2 MB
- fore__Knee_Joint_Screw.stl STL · 94 KB
- fore_Ankle_Joint_Screw_.stl STL · 94 KB
- Head-Mandible.stl STL · 4,6 MB
- Head-Maxilla.stl STL · 11,6 MB
- hind_Ankle_Joint_Screw.stl STL · 95 KB
- hind_Knee_Joint_Screw.stl STL · 95 KB
- Left_fore_Foot.stl STL · 1,7 MB
- Left_fore_Lower_leg.stl STL · 3,4 MB
- Left_fore_Thigh.stl STL · 4,1 MB
- Left_hind_Foot.stl STL · 2,0 MB
- Left_hind_Lower_leg.stl STL · 3,8 MB
- Left_hindThigh.stl STL · 5,5 MB
- Neck.stl STL · 7,6 MB
- Right_fore_Foot.stl STL · 1,7 MB
- Right_fore_Lower_leg.stl STL · 3,4 MB
- Right_fore_Thigh.stl STL · 4,1 MB
- Right_hind_Foot.stl STL · 2,0 MB
- Right_hind_Lower_leg.stl STL · 3,8 MB
- Right_hind_Thigh.stl STL · 5,5 MB
- Tail_1.stl STL · 11,5 MB
- Tail_2.stl STL · 9,7 MB
- Categoría
- Varios
- Formatos
- 3MF, STL
- Descargas
- 413
- Publicado
Sobre este modelo
This is a Ankylosaurus model consisting of 18 parts, capable of limited articulation after assembly. Before you begin printing, please note the following: - Model Scaling: Scaling down the model is not recommended. However, depending on your filament quality, you may slightly upscale it. I recommend test printing the head and tail first.
- Supports required. - Recommended material: PETG for longer-lasting joints, though PLA can be assembled fine too. - 3D Printed Screws: The screws used to secure the joints are 3D printed. Depending on filament quality, they can snap easily, so do not overtighten them.
[Oct 23 Update] Just launched my Patreon! Become a paid member to suggest ideas and vote on the theme for my next poseable model.
The diagram below shows the dinosaur models I have created so far. Links to paid 3D models: https://cults3d.com/en/users/robot3dart/3d-models
Descripción original del autor, publicada en Thingiverse.
