Jewelry Holder
por florianleon en Cults3D
This is a jewelry stand/holder made to hold and show rings, necklaces, earrings and bracelets.
Cults3D entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a florianleon.
Archivos (5)
- bottom_support.stl STL
- bracelet_rod.stl STL
- bracelet_rod_support.stl STL
- hook.stl STL
- necklace_holder.stl STL
- Categoría
- Moda y joyería
- Formatos
- STL
- Descargas
- 2,000
- Publicado
Sobre este modelo
This is a jewelry stand/holder made to hold and show rings, necklaces, earrings and bracelets.
It comes in 5 different parts:
- A bottom support made for the rings
- A support for the bracelet rod that need to be strong
- A bracelet rod to hold the bracelet
- A necklace holder that holds both necklaces and earrings (support and brim are recommended for this piece)
- A hook (you need 8 pieces) to hold the necklaces
Depending of the printer you might need to cut the edges of the holes a little bit.
You will only need a scalpel to cut some of the edges and super glue
Assembly:
- Glue the bracelet Rod to its support
- Make sure that the notch can enter the hole of the bottom support
- Put a line of glue on top of the notch on the bracelet rod support for extra stability (not compulsory)
- Put each hook into the necklace holder (you might need to use the scalpel here)
- Make sure that the notch of the necklace support can enter the hole of the bottom support
Descripción original del autor, publicada en Cults3D.
