jewelry box
por Markus710 en Printables
jewelry box for Rings, Earrings, necklaces and other stuff
Licencia
Solo uso personalCC BY-NC-ND 4.0 — Atribución, no comercial, sin derivadas
Solo para uso personal, sin modificarlo y dando crédito. No se permite vender ni redistribuir cambios.
Al descargar aceptas respetar la licencia y dar crédito a Markus710.
Archivos (22)
- Frame Bottom.stl STL · 485 KB
- Frame Top.stl STL · 1007 KB
- Axis.stl STL · 92 KB
- Drawer 1 compartment.stl STL · 1,1 MB
- Drawer 2 compartments.stl STL · 1,2 MB
- Drawer for rings and earrings.stl STL · 898 KB
- Drawer for rings and earrings.stl STL · 898 KB
- Ring holder left.stl STL · 3,2 MB
- Ring holder right.stl STL · 3,2 MB
- Earring holder 3.stl STL · 425 KB
- Earring holder 4.stl STL · 342 KB
- Earring holder 2.stl STL · 570 KB
- Earring holder 1.stl STL · 957 KB
- ring holder for earring compartment.stl STL · 3,0 MB
- Frame 6x2.stl STL · 485 KB
- 1 compartement 6x2.stl STL · 1,1 MB
- 2 compartements 6x2.stl STL · 1,2 MB
- Ring Earring compartements 6x2.stl STL · 898 KB
- Frame Bottom.stl STL · 485 KB
- 1 compartement.stl STL · 1,1 MB
- 2 Compartement.stl STL · 1,2 MB
- Earring.stl STL · 898 KB
- Categoría
- Moda y joyería
- Formatos
- STL
- Descargas
- 3,892
- Publicado
Sobre este modelo
Hello, I made this jewelry box for my girlfriend. So she can store rings, Earrings and other stuff like necklace.
I made inputs for little magnets that the Drawers shut in a straight line. You need 16 of these. The original model is printed for 5x1 Magnets. I used this one, but you can use any other magnets that fit in the holes. Magnets I made a version for 6x2mm Magnets. I made a version for 6x2.7mm Magnets too. If you need any other magnet size, pls comment it and i will make an update on the model if its possible.
It Should be possible to print every thing without support. I had no problems printing it without support on my bambu lab.
You need four drawers. Put them above each other and glue the axis and top in place. If you want the drawer for Rings and earrings you need: - 2x Every Earring holder - 1x TPU Ring holder left - 1x TPU Ring holder right - 1x The Drawer for rings and earrings
I would print the Ringholders in TPU that the rings get no scratches and are easy to put in and remove.
Descripción original del autor, publicada en Printables.
