iSpindel holder and calibration base
por David Bulnes en MyMiniFactory
This design is solving a small problem I had when servicing and charging my iSpindel devices. They were more than often laying on the bed or desk, moving aorund etc. I decided I could fix this, so this base was born. It fits the large Petling around 50mm diameter and holds it straight up. Also the b
Licencia
Solo uso personalMyMiniFactory Exclusive - Credit - Remix - Noncommercial
Licencia de MyMiniFactory: puedes imprimirlo y remezclarlo dando crédito, sin fines comerciales.
Al descargar aceptas respetar la licencia y dar crédito a David Bulnes.
Archivos (1)
- Categoría
- Para tu impresora
- Formatos
- STL
- Descargas
- 67
- Publicado
Sobre este modelo
This design is solving a small problem I had when servicing and charging my iSpindel devices. They were more than often laying on the bed or desk, moving aorund etc. I decided I could fix this, so this base was born. It fits the large Petling around 50mm diameter and holds it straight up. Also the base works as a small stand to calibrate the 90 degrees or zeroing the device. I tried to make it modular so that pieces snap together when having more than 1, it does work but i would need to work on thos snap fittings more, for the time being i would use just glue on those sides.
Leave a comment and any feedback if you wish, it would be greatly appreciated.
Cheers! Happy Printing and Brewing!
Descripción original del autor, publicada en MyMiniFactory.
