IronLogic Z-5R NET Access Control Controller Case
por ANTON KOVALEV en Thingiverse
A 3D printable enclosure for the IronLogic Z-5R NET access control controller, specifically the network version with RS-485 interface. The controller is held in place by snap-fit clips. The enclosure is intentionally oversized to make wiring and connections easier, especially when using WAGO...
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a ANTON KOVALEV.
Archivos (1)
- Categoría
- Herramientas
- Formatos
- STL
- Descargas
- 0
- Publicado
Sobre este modelo
A 3D printable enclosure for the IronLogic Z-5R NET access control controller, specifically the network version with RS-485 interface. The controller is held in place by snap-fit clips. The enclosure is intentionally oversized to make wiring and connections easier, especially when using WAGO connectors. If you mount the enclosure to a wall using the screw hole underneath the PCB, make sure to cover the screw head with electrical tape to prevent accidental short circuits. The enclosure has removable cable entry knockouts on three sides. Simply cut out the ones you need. The lid can be secured with self-tapping screws, or you can heat-set threaded nuts into the enclosure and use machine screws instead. There is also a hole for the status LED and a grille for the buzzer.
Descripción original del autor, publicada en Thingiverse.
