Interior Doggie Door
por OptiSync Inc. en MyMiniFactory
This was just a simple design I made so that my pets could go in and out of our bedroom so that we wouldn't need to open the door for them. Made for smaller pets and to fit a typical builder grade interior door.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a OptiSync Inc..
Archivos (3)
- Categoría
- Hogar
- Formatos
- STL
- Descargas
- 46
- Publicado
Sobre este modelo
This was just a simple design I made so that my pets could go in and out of our bedroom so that we wouldn't need to open the door for them. Made for smaller pets and to fit a typical builder grade interior door.
I have two designs. Simple flat and panel style.
This will require a two 608 (8mm Inner Diameter x 22mm Outer Diameter x 7mm Width) bearings for the swinging door. Should snap right in to the door pegs and will be held in by pressure when you mount it buy sandwiching your door. I put slots to fit some cheap magnets you can buy at Amazon. They measure around 5x6x22mm.
I have printed it but haven't mounted it yet.
Let me know what you think
Support OptiSyncInc
Descripción original del autor, publicada en MyMiniFactory.
