INDX 8 Tool Shakedown Test gcode (no filament needed)
por TeamADW en Printables
Needed a short test routine to test INDX tube routing and dock mounts.
Licencia
Uso comercial permitidoPuedes imprimirlo, modificarlo y venderlo sin pedir permiso ni dar crédito.
Al descargar aceptas respetar la licencia y dar crédito a TeamADW.
Archivos (1)
- Categoría
- Para tu impresora
- Formatos
- GCODE
- Descargas (todas las plataformas)
- 0
- Publicado
Sobre este modelo
Part of my Core One 8T INDX setup was dealing with filament mounted below the machine to reduce drag in the tubes with some filaments. In testing setups, I found some less than ideal configurations for the filament sensors, and had issues with PTFE collisions which would knock tools off the docks.
This routine was created with help from grok so I didnt need to wait for heat cycles and calibration. It picks up each tool, makes a square pattern, then a zigzag to move the head around as much as possible. It does this in order from T1-T8, and then cycles through tools at random.
No filament is needed, just drop the code either in connect or your USB drive and hit print. Watch your tubes, with the lid closed and open.
Descripción original del autor, publicada en Printables.
