Imperator CD32 Amiga Riser Adapter USB VGA RGB DB23 Jack 3.5mm Cover

I have modified the original item from Hefesto to close up the left hand hole and add the 3.5mm Jack and modify the positions of the other holes, to enable it to fit the riser card. I have the Imperator CD32 Riser from sordan.ie and there were no visible prints for this, so I have fixed this! My CD32 has an 060 board that has a disable jumper on board. I found that it would not play any CD when the 060 board is enabled. I have now added a hole for a small simple switch to enable this to be turned on or off as necessary (only switched when CD32 is powered off(). I have a picture of the switch as well as my extension for the SD card, that routes through the gap, to make swapping SD cards a simplicity. If you had a larger CF Card and swap to the SD card, you need to cut pin 1 of the hard drive cable to fix a problem of low volume. After doing this, you can then use an SD version of the connector, and extend to the side of the CD32. During printing, I used Cura and opted for a Tree for support (only needed in the version with the hole) and had to scale by an extra 3% to maintain the size. I used this switch - Miniature On-On Round 15mm Rocker Switch SPDT https://ebay.io/m/8TJYbi Found some cables with connectors to fit the Pins of the jumper and soldered these to the middle and one nearest the circle indicator. This way when I press the line it was on, the circle turned it off. I had to manoeuvre the cover to slide on from the left and slot the switch pins just behind the riser card and then slot into place. I am happy with my version and hope you enjoy this update to the CD32!