Holiday Gift Box (Nice Version)
por DustinJay en Printables
A reusable holiday gift box printed in PLA. Prints in two pieces, the base and the lid.
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a DustinJay.
Archivos (6)
- gift-box-nice-version-base.stl STL · 51 KB
- gift-box-nice-version-base.3mf 3MF · 13 KB
- gift-box-nice-version-lid.3mf 3MF · 231 KB
- gift-box-nice-version-lid.stl STL · 889 KB
- gift-box-nice-version-base_02mm_pla_mk3s_10h25m.gcode GCODE · 9,1 MB
- gift-box-nice-version-lid_02mm_pla_mk3s_10h32m.gcode GCODE · 39,5 MB
- Categoría
- Organización
- Formatos
- STL, 3MF, GCODE
- Descargas
- 2,599
- Publicado
Sobre este modelo
A reusable holiday gift box printed in PLA. Prints in two pieces, the base and the lid. Change the color for the lid ribbon with a pause and filament swap (built into the gcode file here). No supports needed.
The pictured box was printed with Prusament PLA Opal Green and Lipstick Red.
Naughty Version (one piece smash-to-open) can be found here:
https://www.prusaprinters.org/prints/13938-holiday-gift-box-naughty-version-smash-to-open
Print instructions 0.2mm Layer Height
15% Infill
Use a Brim
If slicing the attached STL, add a pause for the color change at the ribbon on the Lid file.
Descripción original del autor, publicada en Printables.
