Hobie Rudder Pin

This is a replacement rudder pin modelled for the Hobie Tandem Island kayak.

Warnings - Use at your own risk. - This has not been tested on the water for any length of time, and I make no claims about its durability. - It is intended only as a last-resort emergency replacement in otherwise safe conditions. - Sea water and sunlight can degrade plastic, so print in a suitable material. - Always have an alternative means of steering. - Do not venture far out with this fitted.

Print Instructions - Print with the flat side down on the bed. - Use a high wall count and high infill. - Print for maximum strength throughout. In particular:- From the main shaft to the top of the pin, each layer must be printed in one continuous run, with no separate islands, stops or restarts.