Hobie Outrigger Connector
por Simon St en Thingiverse
Designed for the Hobie Tandem Island kayak. M5 x 0.8 thread modelled in place of the original hole. If you don't have an M5 bolt on hand, flip the part over and screw through the solid plastic. If you've managed to break one of these at sea, you're probably having a bad day. If you're still afloat..
Licencia
Solo uso personalCC BY-NC 4.0 — Atribución, no comercial
Puedes imprimirlo y modificarlo para uso personal dando crédito. No se permite vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a Simon St.
- Categoría
- Jardín
- Formatos
- 3MF, STEP
- Descargas
- 2
- Publicado
Sobre este modelo
Designed for the Hobie Tandem Island kayak. M5 x 0.8 thread modelled in place of the original hole. If you don't have an M5 bolt on hand, flip the part over and screw through the solid plastic. If you've managed to break one of these at sea, you're probably having a bad day. If you're still afloat, I hope this helps!
Print Settings - No supports needed. - A brim (or a raft) can help keep it stable and stuck to the bed during the print. - The only overhang is the outer disc, which sticks out just 4.3 mm. Turn on Extra Perimeters on Overhangs (PrusaSlicer/OrcaSlicer) and it should print cleanly.
Descripción original del autor, publicada en Thingiverse.
