Hinged lid for adding MMU2S to Original Prusa Enclosure
por Prusa Research en Printables
Printable accessory, providing access to the printer and MMU from the top. Designed for the Original Prusa Enclosure.
Licencia
Uso comercial permitidoPuedes usarlo, modificarlo y venderlo; si distribuyes versiones modificadas deben ir con la misma licencia y sus fuentes.
Al descargar aceptas respetar la licencia y dar crédito a Prusa Research.
Archivos (12)
- Hinged-Lid-Complete.3mf 3MF · 776 KB
- Lid-handle.stl STL · 1,7 MB
- Hinge-bracket-R.stl STL · 212 KB
- Hinge-bracket-L.stl STL · 199 KB
- Hinge-lever.stl STL · 113 KB
- Lid-lock.stl STL · 137 KB
- Top-plug-rear.stl STL · 41 KB
- MMU-grommet.stl STL · 41 KB
- MMU-buffer-feet.stl STL · 284 KB
- Hinge-bracket-Rt.stl STL · 254 KB
- Hinged-Lid-Complete_0.3mm_PETG_MK3S_5h56m.gcode GCODE · 11,5 MB
- Hinged-Lid-MMU-Complete_0.3mm_PETG_MK3S_8h32m.gcode GCODE · 15,2 MB
- Categoría
- Para tu impresora
- Formatos
- 3MF, STL, GCODE
- Descargas
- 10,202
- Publicado
Sobre este modelo
Printable accessory for Original Prusa Enclosure developed to enable access from the top. Can be used for a standalone printer or for a printer with a multi-material unit on the frame. Check the step-by-step guide on how to install the Hinged lid. In case you want to use the Hinged Lid without the MMU you can use Hinged-Lid-Complete_0.3mm_PETG_MK3S_5h58m.gcode or you can turn off MMU-grommet in the 3mf file In case you want to use the Hinged Lid with Advanced Filtration System you need to print Hinge-bracket-Rt instead of Hinge-bracket-R To mount the Hinged lid you will need the following fasteners*: - M3x8 screw (15x) - M3nS nut (1x) - M3 nut (8x) - Pin 3x20 (2x)
* The package of the Original Prusa Enclosure includes extra fasteners, which were added in case you wanted to install the Hinged Lid.
Print instructions You have three options: - use the pre-sliced G-code and print it on your MK3S+ - use .3mf file for accurate setting of perimeters and supports - download the latest PrusaSlicer and use the following settings**:- print settings: 0.30mm DRAFT - filament: PETG (tested on Prusament) - 20% grid infill - minimum of 8 perimeters - turn on thin wall detection
** Note that this setting is the minimum possible due to the strength of the parts, but you can experiment with your own settings.
Descripción original del autor, publicada en Printables.
