Hiking Container - Robust and Waterproof
por JANBERRY DESIGN en MakerWorld
Hiking Container. Robust, small outdoor container for your hiking, camping, fishing or other adventure trips.
MakerWorld entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalStandard Digital File License
Licencia estándar de archivos digitales: solo uso personal. No se permite compartir, revender ni subir el archivo a otros sitios, ni vender las impresiones.
Al descargar aceptas respetar la licencia y dar crédito a JANBERRY DESIGN.
- Categoría
- Jardín
- Descargas
- 9,055
- Publicado
Sobre este modelo
Hiking Container
Robust, small outdoor container for your hiking, camping, fishing or other adventure trips.
Size ~ 90 mm x 67 mm x 36 mm
Features
- robust design
- waterproof (if you use the foam rubber sealing) (TPU seal might follow)
- robust hinge
- hole for paracord attachment
- pocket size
Print Print Time: ~ 2.5 hours Filament Use: ~ 70 g (1.3 g Support material)
PLEASE PRINT WITH SUPPORT! The latch mechanism is tuned to a few tenth of a mm. Even if the overhang gets printed without the support it will never be accurate enough. The right support settings are in the printprofile. I would recommend to use the support type "standart" and style “snug”
I would recommend to clean the print plate with isopropanol and put some glue on it.
Assembly A little bit of support is needed to make sure that this design is printable. Please make sure that you clean it before assembly.
What else to i need? M4 x 20 mm Cylinderhead Screw Optional: Foam rubber sealing Membership
Waterproofness I left it outside in the rain for a few ours. Even without the seal there was no water in it. But if you need it to be waterproof when dipping it shortly under water you need to put in the foam rubber sealing.
Boost Me Check out my other models.
Descripción original del autor, publicada en MakerWorld.
