Herman Ohme's Chess Set
This is a set of chess pieces originally designed by Herman Ohme in 1953. Models were made with the most careful reproduction of the original design and taking into account the easiness of printing. The height of the tallest figure (king) is 11 cm.
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a kosteklvp.
Archivos (8)
- Bishop.3mf 3MF · 437 KB
- King.3mf 3MF · 352 KB
- Knight.3mf 3MF · 460 KB
- Pawn.3mf 3MF · 534 KB
- Queen.3mf 3MF · 380 KB
- Rook.3mf 3MF · 553 KB
- Full Set.3mf 3MF · 618 KB
- USD171286.pdf PDF
- Categoría
- Miniaturas
- Formatos
- 3MF, PDF
- Descargas
- 152
- Publicado
Sobre este modelo
This is a set of chess pieces originally designed by Herman Ohme in 1953. Models were made with the most careful reproduction of the original design and taking into account the easiness of printing. The height of the tallest figure (king) is 11 cm.
---
Recommended print settings - infill: 5% gyroid - perimeters: 3 - minimum bottom shell thickness: 3 mm - supports: no
The hardest part to print is under the knight's jaw. It should print effortlessly, but slowing down bridge's speed to 10 mm/s is recommended.
The tip of the king also should be printed very slowly to avoid unwanted deformations.
A thicker shell at the bottom is recommended for better stability.
---
Credits
Models were reproduced according to US patent 171286, which is available as an attachment.
Descripción original del autor, publicada en Thangs.
