Heltec Wireless Paper v1.2 Case
por Daniel Lopes en Thingiverse
A case to house a battery underneath, and support the e-Ink reader at an angle - while using the acrylic protector The top part was 3d printed upright with the top horizontal as to make a good mating surface for the board, with supports. If you get it to work with ESPHome, do let me know! I Had to..
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Daniel Lopes.
- Categoría
- Tecnología
- Formatos
- STL
- Descargas
- 56
- Publicado
Sobre este modelo
A case to house a battery underneath, and support the e-Ink reader at an angle - while using the acrylic protector The top part was 3d printed upright with the top horizontal as to make a good mating surface for the board, with supports. If you get it to work with ESPHome, do let me know! I Had to resort to Arduino IDE.
Descripción original del autor, publicada en Thingiverse.
