Headphone / Headset Hook for IKEA Skadis
por Zimjo en Printables
Headset hook for the IKEA Skadis pegboard. Original model by @Joe_1165648.
Licencia
Uso comercial permitidoCC BY-SA 4.0 — Atribución, compartir igual
Puedes usarlo y modificarlo dando crédito; las versiones modificadas deben compartirse con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Zimjo.
Archivos (1)
- Categoría
- Organización
- Formatos
- STL
- Descargas
- 124
- Publicado
Sobre este modelo
I couldn't find any 3d models I liked for storing my headset on a Skådis, so I remixed the one made by @Joe_1165648. I printed this holder on one of its sides with maybe a bit too much support. Used Filament: Anycubic PLA White. Layer Height: 0.20mm. Brim: Yes. The contact area of the part on the build plate is pretty small. Supports: Yes, tree supports. The pegs require supports, but the main curvature for the Headset may not. I put some there just to be safe. Infill: 15% Gyroid. Thanks to @Joe_1165648 for the original file!
Descripción original del autor, publicada en Printables.
