Headband, Flowers and Bows
por Hex2000 en Printables
I was designing the flowers when this competition came up and I thought they would be great for a head band.
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Hex2000.
Archivos (6)
- Categoría
- Moda y joyería
- Formatos
- STL
- Descargas
- 1,171
- Publicado
Sobre este modelo
I was designing the flowers when this competition came up and I thought they would be great for a head band. My wife then suggested a Bow!
Hope you enjoy.
There are so many great colours in PLA now that the headband would look great on its own.
The flower stl files are created at the smallest size in the photographs. To get the larger flowers I just doubled up in Prusa Slicer (no point in creating more files for the sake of it)
The Bow size was created to match the larger flowers.
I have created a small slider so you do not have to position your flower/Bow in one particular place, it is a tight fit as I didn't want it too loose.
One word of warning put the clip on the headband before you superglue a flower to it, otherwise you will not be able to get the large flower over the curved section of the headband.
The smaller sized flowers are great if you want to add more than one flower to the band.
It is just down to your own imagination to mix and match colours.
Print instructions I printed with normal PrusaSlicer settings for PLA.
No supports required, even for the Bow.
I printed the headband and clip at 0.2mm layer height.
The flowers were printed at 1.5mm quality layers.
Descripción original del autor, publicada en Printables.
