Haunted Tree Cupcake Stand – 3-Tier Spiderweb

A dead tree that holds 18 cupcakes: put it in the middle of the Halloween table and the bats hanging from its branches float above the frosting. Three spiderweb-engraved trays (230, 190 and 150 mm) slide down the trunk from the top and rest on its steps, and the crown plugs into a knot on top. All 8 parts print flat with no supports and go together without glue.

WHY YOU'LL LIKE IT - 3-tier presentation: holds 18 standard cupcakes (8 on the 230 mm base tray, 6 on the 190 mm tray, and 4 on the 150 mm top tray). - Generous tier clearance: vertical spacing of 81 mm and 76 mm leaves ample room for tall frosting swirls and decorative toppers. - 100% tool-free flat-pack assembly: two interlocking trunk panels cross at mid-lap, trays slide on from above onto integrated stepped shoulders, and the crown locks into the central collar. - Large display on standard printers: total assembled height reaches ~395 mm (395.2 mm), yet every individual piece fits on a 256 × 256 mm bed (largest tray is 230 mm). - Zero supports: all 8 parts lie flat on the print bed with zero overhangs. - Food safety reminder: trays are decorative displays intended for cupcakes in paper baking liners; use food-safe filament or parchment liners for direct food contact.

WHAT'S INCLUDED - 8 STL files: 3 trays (230, 190, 150 mm), 2 trunk panels (A and B), 1 central knot, and 2 crown panels (A and B). - Original design.

#cultsoween

PRINT SETTINGS (suggested) - Supports: none · Layer: 0.2 mm · Walls: 3 · Infill: 15–20 % · Nozzle: 0.4 mm - Material: PLA - Orientation: all 8 parts flat on the build plate - Colors: black trunk panels, knot collar, and crown; orange or purple spiderweb trays Settings are suggestions. Every part was checked in CAD for printability: no supports, clean watertight mesh.

ASSEMBLY & CARE 1. Print all 8 pieces flat on the build plate. 2. Interlock trunk panel A and trunk panel B at their center slots. 3. Thread trays from the top down: 230 mm first, then 190 mm, then 150 mm onto their resting steps. 4. Place the central knot collar onto the upper trunk cross. 5. Slot crown panels A and B together and insert into the central knot. 6. Decorative stand for wrapped cupcakes or pastries with paper liners. 7. Clean gently by hand with lukewarm water.

LICENSE Personal use only: print it as many times as you like for yourself, friends and family. Please don't share or resell the files. Want to sell prints? A commercial license is available — just send me a message.

Post a Make when you print it — I'd love to see your colors!