Hanging Skeleton Buddy

Add a little spooky humor to your Halloween decorations with this Hanging Skeleton! 💀

The skeleton is designed to hang from shelves, furniture, monitors, lamps, or anywhere else where its hand can get a good grip. Its dangling body and playful pose make it a fun little decoration for your desk, room, or Halloween setup.

I created three different poses to add some variety, so you can hang a few of them together and create your own little skeleton crew.

The skeleton is printed horizontally for better strength. Despite its thin and delicate appearance, it’s surprisingly durable and can handle small accidental drops without falling apart.

However, because the model contains small and thin parts, please be careful when removing the supports. Take your time and remove them patiently to avoid damaging any of the smaller bones. In my print profile, I increased the Top Z Distance to 0.27 mm to make the supports easier to separate from the model. If this value is too high for your printer and the supported areas don’t print well, simply reduce the Top Z Distance and try again.

Check out my other Halloween models in my collection 🎃 https://makerworld.com/en/collections/2834940-halloween