Hand Holder
por Paul en Printables
Give your remote, glasses, or whatever, a hand. UPDATE: Print pauses for a sand pour! Organic supports!
Licencia
Solo uso personalCC BY-NC-SA 4.0 — Atribución, no comercial, compartir igual
Uso personal dando crédito; sin fines comerciales y las modificaciones con la misma licencia.
Al descargar aceptas respetar la licencia y dar crédito a Paul.
Archivos (7)
- Right Hand Holder v3.1.3mf 3MF · 51 KB
- Left Hand Holder v3.3mf 3MF · 51 KB
- Hand Holding Remote v3.stl STL · 80 KB
- Hand Holding Remote (Larger w pause to add weight) v3_0.4n_0.2mm_PLA_MINIIS_7h32m.bgcode BGCODE · 7,2 MB
- Hand Holding Remote (Larger with pause for sand weight) v3_0.2mm_PLA_MINI_10h38m.gcode GCODE · 17,9 MB
- Hand Holding Remote v3_0.2mm_PLA_MINI_7h34m.gcode GCODE · 9,7 MB
- Left Hand Holding Remote v3_0.2mm_PLA_MINI_13h17m.gcode GCODE · 14,3 MB
- Categoría
- Hogar
- Formatos
- 3MF, STL, BGCODE, GCODE
- Descargas
- 5,403
- Publicado
Sobre este modelo
I used Polycam, Blender, and Fusion 360 to create this low-poly remote holder. I'm excited to use this workflow to make more things! Print it with some shiny PLA to get maximum reflections from the faces of this low-poly design. Print with supports: Use the 3mf file in Prusaslicer or the gcode for my setup. Consider scaling up a bit for large remotes. I also highly recommend that you follow @Misha.in's make of the design: A great model that enlivened the living room. First, I printed out the attached gcode, but I found a few flaws in it. Mainly it was very light and fragile. Therefore, I doubled the number of perimeters to 4 and poured sand into the model during printing. Now the hand is steady as a rock.
Also, Special thanks to @TritonPrint3D for the photo. Check @TritonPrint3D on YouTube:
Descripción original del autor, publicada en Printables.
