Halloween Pumpkin LED Tea Light Holder –Easy Print
Overview
Thangs entrega los archivos a usuarios con cuenta gratuita
Licencia
Revisa las condicionesStandard Personal Use License
El autor usa su propia licencia. Revisa sus condiciones en la página original antes de compartir, modificar o vender.
Al descargar aceptas respetar la licencia y dar crédito a 3d C.
Archivos (3)
- Tea Light Holder.3mf 3MF · 4,6 MB
- Base.stl STL
- Pumpkin.stl STL
- Categoría
- Jardín
- Formatos
- 3MF, STL
- Descargas
- 12
- Publicado
Sobre este modelo
Overview
Add an eerie, warm glow to your desk or spooky setup with this Jack-o'-Lantern LED Tea Light Lamp! Designed specifically for clean, hassle-free FDM printing without needing multi-material systems like the AMS.
The model prints in two separate pieces—a textured base with an integrated tea light cavity and a carved pumpkin shell. The pumpkin features a simple, single filament swap at the top to give the stem its realistic brown finish.
Features
Zero Waste / No AMS Required: Designed for standard single-extruder printers using a simple layer-pause filament swap for the stem.
Standard Fit: Built for standard 38 mm battery-operated LED tea lights (CR2032).
Easy Access: Sits cleanly on the base for quick on/off switching and battery replacement without fuss.
Support-Free Design: Tuned overhangs and bridged facial features print cleanly on standard profiles.
Recommended Print Settings
Layer Height: 0.20 mm (Standard)
Walls/Perimeters: 2 to 3 (allows the light to glow through the walls subtly while keeping details sharp)
Infill: 10–15% Gyroid or Cross Hatch
Supports: None needed
Filament Swap (Pumpkin Top): Insert a pause in your slicer right at the layer where the pumpkin body ends and the stem begins to switch from Orange to Brown.
Safety Note: Use LED tea lights ONLY. Do not use real candles or open flames with PLA/PETG prints.
Descripción original del autor, publicada en Thangs.
